elcome to this Online Course on 2005 NEC for Control Wiring covering Motor Control, Class 1, Class 2, and Class 3 Circuits brought to you by electrician.com now Updated to the 2005 NEC.

 
his course is designed for continuing education to be performed Online.  There are 40 webpages, 75 graphics with one Quiz links located on every fifth page.  A server graded and recorded quiz that is for persons doing this course for 8 hours of verifiable continuing education and who have received the username and password is located on every fifth page. 

I first wrote this course in 1990 at the request of the State of Alaska Department of Labor.  At that time many mechanical contractors were moving from pneumatic controls to electronic controls and were  installing their own control wiring subject to the rules found in the National Electrical Code.  This became a problem when State Electrical Inspectors inspected these systems and observed an unusually high number of nonconforming items, and I was one of those inspectors.  A commitment was made by the Department of Labor to train mechanical contractors on pertinent rules found in the National Electrical Code.  That promise resulted in this course.  Since 1990 I have revised this course four times to keep abreast of the NEC revisions that are published every three years.  This current revision, revision No. 5,  is much more extensive than previous versions because I have had the fortunate experience of performing electrical wiring for a major Control Contractor specializing in HVAC and process controls for the last year and one half.  This experience has increased my field knowledge of control wiring and allowed me to work with some very fine control installers, programmers, and engineers.

This course is for anyone doing control wiring subject to the National Electrical Code and is an excellent introduction to the National Electrical Code for Mechanical Contractor persons that are required to perform electrical control work in accordance with the NEC.

The navigator frame on the left allows you to navigate through the tests and material.  The calculator buttons at the bottom allow you to open a calculator window at any time while reviewing the material.  Also, the special music selector allows users of IE to listen to background midi music.
 


When using frames and IE 4.0 simply slide the left hand frame border to the left with your mouse to view the material with a fuller screen. Also, with IE 4.0 use the full screen tool and you will have presentation quality.
The NEC® and National Electrical Code® are registered trademarks of the National Fire Protection Association. Whenever possible, the word "Code" is used in place of NEC®.

Try the first Lesson!